Lo sentimos, este PDF solo está disponible en formato para descarga

Getting Started Guide: Intel® UDK 2010 Firmware Developer Platform Kit

Intel® UDK2010 Firmware Developer Platform Kit

Introduction

Welcome to the Intel® UDK2010 Firmware Developer Platform Kit Getting Started Guide. This guide explains how to install a Unified Extensible Framework Interface (UEFI) 2.3-compliant BIOS image on an Intel® UEFI Development Kit 2010 (Intel® UDK2010) firmware developer platform that supports the development, test, and debugging of UEFI 2.3-compliant drivers and applications.

Scope

This guide explains the process of installing an Intel UDK2010 firmware developer platform UEFI 2.3 BIOS image on an assembled or purchased Intel UDK2010 firmware developer platform. Note that firmware developer platforms must be assembled from components found in the supported hardware list in Table 1-1. The guide covers:
• Backing up and erasing existing production BIOS from a motherboard using an SPI Flash programmer
• Programming in a new Intel UDK2010 firmware developer platform BIOS image
• Verifying that the Intel UDK2010 firmware developer platform BIOS image is programmed correctly
• Troubleshooting information to help if errors occur

This guide assumes that you possess PC hardware assembly skills and familiarity with Microsoft Windows* environments. This guide does not explain PC assembly or Microsoft operating systems.

Read the full Firmware Developer Platform Kit.

Intel® UDK2010 Firmware Developer Platform Kit

Introduction

Welcome to the Intel® UDK2010 Firmware Developer Platform Kit Getting Started Guide. This guide explains how to install a Unified Extensible Framework Interface (UEFI) 2.3-compliant BIOS image on an Intel® UEFI Development Kit 2010 (Intel® UDK2010) firmware developer platform that supports the development, test, and debugging of UEFI 2.3-compliant drivers and applications.

Scope

This guide explains the process of installing an Intel UDK2010 firmware developer platform UEFI 2.3 BIOS image on an assembled or purchased Intel UDK2010 firmware developer platform. Note that firmware developer platforms must be assembled from components found in the supported hardware list in Table 1-1. The guide covers:
• Backing up and erasing existing production BIOS from a motherboard using an SPI Flash programmer
• Programming in a new Intel UDK2010 firmware developer platform BIOS image
• Verifying that the Intel UDK2010 firmware developer platform BIOS image is programmed correctly
• Troubleshooting information to help if errors occur

This guide assumes that you possess PC hardware assembly skills and familiarity with Microsoft Windows* environments. This guide does not explain PC assembly or Microsoft operating systems.

Read the full Firmware Developer Platform Kit.

Vídeos relacionados